Guralp-systems Scream Manual de usuario descargar pdf (Pagina 128)

Scream! 4.5

11.2 E-mail notification

You can also instruct Scream! to send e-mail to warn the operator

when particular events happen. To set this up, choose File Setup…→

from the main menu and move to the Email Options tab.

To be able to use e-mail, you will need access to a mail (SMTP) server

which will accept messages from the address

Scream_SMTP_client@your-hostname. Fill in the IP address or

hostname of this server in the SMTP Server box. Enter in the

Recipient box the e-mail address to which you want the mail sent.

The events you can monitor are:

Digitiser re-boots : Scream! can recognise the boot-up status messages

of a Güralp digitiser or digital instrument. These are normal after a

power cycle, or when a new configuration is uploaded to the digitiser.

After a re-boot, you should receive Re-Sync and Data Discontinuity

messages as well.

Re-Syncs : Whenever the digitiser's internal clock is resynchronized

with GPS. These are normal after a re-boot, or an extended period of

GPS outage.

Data Discontinuities : Any detected gap in a stream, along with the

reason, if known. This includes reboots, clock syncs, and intentional

gaps in triggered channels, as well as data lost owing to slow or

poor-quality communications links. You should check the log files

(see above) to help you determine the cause.

SAM disk full : SAM units send status messages when they stop

recording data because their disk is full. SAM units in circular-buffer

128 Issue K

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 141 142

Sin comentarios

Guralp-systems Scream Manual de usuario Pagina 128