Guralp-systems CMG-3ESPCD Manual de usuario descargar pdf (Pagina 74)

CMG-3ESPCD Digital Broadband Seismometer Command line interface

component letter (N) and a tap number (1). Unlike most FORTH commands,

the stream-id parameter goes after the command.

6.7.10 STATUS-ONLY

Syntax: STATUS-ONLY

Instructs the digitiser to transmit only status streams (text streams, normally

with stream IDs ending in 00.)

6.7.11 S/S

Syntax: rate S/S

Instructs the digitiser to transmit only streams with sample rates equal to

rate. If rate is zero, only status streams are transmitted. Note that this

command should not be confused with the SAMPLES/SEC command.

6.7.12 ALL-TIMES

Syntax: ALL-TIMES

Clears any time selection in force, allowing you to download all data held by

the digitiser. This command does not alter which streams are to be

transmitted; you should specify streams or use the ALL-DATA command in

addition to this one.

6.7.13 FROM-TIME

Syntax: yyyy mm dd hh mm FROM-TIME

Instructs the digitiser to transmit only data more recent than yyyymm-dd

hh:mm, where

• yyyy is a four-digit year (1989 – 2069);

• mm is the month number (1 – 12);

• dd is the day of the month (1 – 31);

• hh is the hour of the day (0 – 23); and

• mm is the minute of the hour (0 – 59).

6.7.14 TO-TIME

Syntax: yyyy mm dd hh mm TO-TIME

Instructs the digitiser to transmit only data more recent than yyyymm-dd

hh:mm, where yyyy, mm, dd, hh and mm have the same meanings as in

FROM-TIME, above.

MAN-C3E-0002 74 Issue B - November 2013

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 97 98

Sin comentarios

Guralp-systems CMG-3ESPCD Manual de usuario Pagina 74